A Snapping Good Time!

Granny D here.  In keeping with our daily themes (Today is 'Sew and Tell Sunday) I thought I'd put together a little tutorial on how to install magnetic snaps.  When making purses and bags, they are the BEST!  They're easy to install, not expensive and these little guys are strong!  Keep in mind, I'm no expert but this is such a simple addition that adds a special touch to your bags and purses.

You'll need 4 pieces for each installation.  Two flat washers, or back pieces, to stabilize the snap (I add fusible interfacing, too) and two outside pieces as shown here.  One has a little bump and one has a corresponding slot for it to fit in.









So, first, I prepare my fabric (in this case, the lining) by putting a square of fusible interfacing on the inside right in the center of the bag.  Then, I use the washer to mark my positioning and mark where the prongs should go through with a pen.   I usually drop it down about an inch from the top to allow for seams. 









Then I snip those open.  I try to make this hole as small as possible so that I almost have to force the prongs through.  Just to be on the safe side.











After that, I push the prongs through the holes I just made.  The snap will be on the outside of your project.












The washer goes in place next.














And then, I spread the prongs open to hold the snap in place.  Once I get them positioned, I try to push them completely flat on a hard surface.

Oh, and then you do the same thing for the other side, using the other half of the snap. 

It takes only a little practice, and you'll be a pro at this in no time.


And that's it.   I learned my lesson about putting them in first, even before I put the pockets on the lining.  Everything sticks to them, pins, scissors, etc. and they are constantly sticking to each other.  Well, they are magnets!  So I waited till the last minute this time and it worked so much better.

Next week, I'll share my thoughts on shaping your bags.  There are square bottoms and softer ones, each requiring a different technique.  Still, very simple, very doable, even for beginners.

Let us know if this was helpful or if there's some other fastener you've found that you just can't live without.

Slow Sewing Week

Granny D here.  It's been a slow sewing week for me.  To much real world stuff to do and I don't like it one bit.

If you'll remember, Monday, I had a beautiful blue and yellow bag prepared to sew.  Remember, I was trying to decide whether to make the back blue or yellow.  I ended up going with blue.








Well, I did manage to get this one completed.  And it turned out pretty good, if I do say so myself.  And I love the little daisy button I found.

But take a look at what I put together just yesterday.  I'm calling this a picnic purse and the body can be made out of a 10" square, well two 10" squares.  I've got some great ideas for that.  It's just big enough for car keys, lipstick and your cell phone.  Maybe some tissues and breath mints.  You know, those essentials you'd take on a picnic.  There are pockets inside and a magnetic closure just inside the top to keep everything safe.  (I learned a lesson about those little guys I'll share with you later.) The strap is long so it can be worn across your body.  Or tuck it down inside if you like and use it as a little clutch.

I think, the first time I saw a picture of this purse, was in a magazine around Christmas time.  They were calling it a party purse.  And, with the right fabric and glittery embellishments this would be the perfect little purse to take to a party.  Of course, I set about making my own pattern but this is the first time I've played with it at all.

So, tell me.  Do you prefer big bags to carry everywhere?  Or do you think, every once in a while, it's nice to just take the bare necessities in a small bag whether it's a picnic or a party?

Finished Product

Granny D here.  Remember all those piece parts I showed you on Monday?  We're calling that Make It Monday, by the way.  Well, all of those parts finally became something special today.

Since these will soon be showing up in our eBay store, I thought you might like to see how one is made.  I'm going to take you kind of step by step as to how I put it together.  As you see each step, feel free to let me know if you think something can be done quicker or easier.  I'm no expert, believe me.
First things first. 
I make the straps, the button flap and the pockets first.

Then I sew the pockets to the lining and put the lining together.  And this time I remembered to leave the 3" to 4" hole in the bottom so I can turn it later.  Sheesh!  I always forget that.  Thank goodness for seam rippers.

After that I start working on the outside of the bag.  I use fusible batting to make it soft and then quilt it just a little.  Then I sew on the straps and the flap.  You'll notice I changed the flap.  When I got ready to sew it on, it was just too wide.  So I just made another one.







Now comes the fun part.  I turn the lining inside out and tuck the bag, right side out into the lining.  Got it.  I just have to keep telling myself right sides together, right sides together...  You get the picture









Then, it's just a matter of sewing around the top of the bag, making sure everything is straight and even and those straps stay out of the way.  I turn it through that little hole I left in the bottom of the lining.  And then, whew, remembered to sew the hole up once I'm sure everything is cool.  Lastly, sew a button on the front to secure the bag somewhat.

And, there you have it.  A patriotic tote, that's roomy enough for just about whatever you might need.  Plus, it has plenty of pockets to help keep things organized.  What do you think?