You'll need 4 pieces for each installation. Two flat washers, or back pieces, to stabilize the snap (I add fusible interfacing, too) and two outside pieces as shown here. One has a little bump and one has a corresponding slot for it to fit in.


Then I snip those open. I try to make this hole as small as possible so that I almost have to force the prongs through. Just to be on the safe side.


The washer goes in place next.

And then, I spread the prongs open to hold the snap in place. Once I get them positioned, I try to push them completely flat on a hard surface.
Oh, and then you do the same thing for the other side, using the other half of the snap.
It takes only a little practice, and you'll be a pro at this in no time.
And that's it. I learned my lesson about putting them in first, even before I put the pockets on the lining. Everything sticks to them, pins, scissors, etc. and they are constantly sticking to each other. Well, they are magnets! So I waited till the last minute this time and it worked so much better.
Next week, I'll share my thoughts on shaping your bags. There are square bottoms and softer ones, each requiring a different technique. Still, very simple, very doable, even for beginners.
Let us know if this was helpful or if there's some other fastener you've found that you just can't live without.
No comments:
Post a Comment